20 Installation and Quick Start
How to Access a Configured Network Management Card
Simple Network
Management
Protocol (SNMP)
After you add the PowerNet MIB to a standard SNMP MIB
browser, you can use that browser to access the Network
Management Card. The default read community name is
public; the default read/write community name is private.
To use InfraStruXure Manager to manage a UPS on the public
network of an InfraStruXure system, you must have SNMP
enabled in the Management Card interface.
To enable or disable SNMP access, you must be an
Administrator. Select the Administration tab, select the
Network menu on the top menu bar, and use the access option
under SNMP on the left navigation menu.
FTP and SCP
You can use FTP (enabled by default) or SCP to transfer
downloaded firmware to a Management Card, or to access a
copy of a Management Card’s event or data logs.
To use InfraStruXure Manager to manage a UPS, you must
have FTP Server enabled in the Management Card interface.
To enable or disable FTP Server access, you must be an
Administrator. Select the Administration tab, select the
Network menu on the top menu bar, and use the FTP Server
option on the left navigation menu.
Analog modem
(AP9618)
The AP9618 Network Management Card EM/MDM has an
internal analog modem you can use for dial-in access to its
Management Card’s control console.
Managing the
security of your
system
See also
In the Network Management Card User’s Guide,
see the following sections:
• To transfer firmware, see “File Transfers.”
• To retrieve a copy of the event or data log, see
“How to use FTP or SCP to retrieve log files.”
See also
For detailed information on enhancing the security
of your system after installation and initial
configuration, see the Security Handbook,
available on the APC Network Management Card
Utility CD and on the APC Web site,
www.apc.com.
To Next Page
Loading...
Need help?
General
