Metered Rack PDU User’s Guide6
Command Line Interface
1. Log on to the command line interface. See “Logging on to the Command Line Interface” on
page 14.
2. Contact your network administrator to obtain the IP address, subnet mask, and default gateway
for the Rack PDU.
3. Use these three commands to configure network settings. (Text in italics indicates a variable.)
a.
tcpip -i yourIPaddress
b.
tcpip -s yourSubnetMask
c.
tcpip -g yourDefaultGateway
For each variable, type a numeric value that has the format xxx.xxx.xxx.xxx.
For example, to set a system IP address of 156.205.14.141, type the following command
and press E
NTER:
tcpip -i 156.205.14.141
4. Type exit. The Rack PDU restarts to apply the changes.
To Next Page
Loading...