13Metered Rack PDU User’s Guide
Command Line Interface
About the Command Line Interface
You can use the command line interface to view the status of and configure and manage the Rack PDU.
In addition, the command line interface enables you to create scripts for automated operation. An
Administrator has full access to the Command Line Interface, a Device user has limited access, and a
Read-Only user is completely restricted. (For additional details, see “Types of User Accounts” on
page 2.)
You can configure all parameters of a Rack PDU (including those for which there are not specific CLI
commands) by using the CLI to transfer an INI file to the Rack PDU. The CLI uses XMODEM to
perform the transfer. However, you cannot read the current INI file through XMODEM.
To Next Page
Loading...