APDM Opal V2R - Charging and Storage; Cleaning Procedures

To Next Page

To Previous Page

Storage

Cleaning

In daily use situations, it is sufficient to simply dock your sensors when not in use. When docked, sensors stop

recording, stop broadcasting, and charge batteries.

For periodic users, it is best to power off all system components for storage and transport. This can be done by

docking the sensors and clicking the “Power Off” button in the Motion Studio menu. The sensors will power down

the next time they are undocked.

As the Opal wearable sensors come in direct contact with subjects, they should be cleaned after every use. To clean

the Opal use a low-level disinfectant on a soft, lint-free cloth. Examples of low-level disinfectants include 70% or

greater isopropyl alcohol, 10% bleach solution, or various commercial disinfectant wipes. Do not immerse in or spray

the Opals with a liquid. Do not use abrasive cleaners.

The Access Point, Docking Station, and all associated cabling do not require cleaning. If you wish to clean these,

please use a mild cleaning solution on a soft, lint-free cloth. Do not immerse in or spray the Access Point or Docking

Station with a liquid. Do not use abrasive cleaners. The sensor straps can be removed and washed separately using

mild soap and water.

Parts

Setup M.L. How to