SERVICE MANUAL
7 STANDBY
Standby mode after power-on: 1ėStandby, 0ėThe
same as last power-off mode
1
0 VM
Velocity modulation: 1ėYes, 0ėNo
1
1 LOCK
Lock used for identifying detection: 1ėYes, 0ėNo
0
2 IDENT_MODE
Lock handle: 1ėTXT12 | Lock; 0ėTXT12 & Lock
0
3
COLOR
MATRIX
Matrix: 1ėUSA; 0 ėJapan
0
4 FORF 0
5 FORS
F/S 00ėAUTO 60 01ė60 FORCED
10ėAUTO LAST 11ėAUTO 50
1
6 CHILD_LOCK
Child lock: 1ėYes, 0ėNo
1
OP8
7 SPEAKER
Speaker On/Off: 1ėYes, 0ėNo
0
0 BKS Black level stretch 1
1 0 0
2 0 0
3 DSK Skin tone correction 1
4 COR0 1
5 COR1
Dynamic coring: 00ėOff 11ėMax.
1
6 SVM0 0
FEA
T
7 SVM1
TDA9379 VM delay 00ė50 01ė70
10ė90 11ėSpare
0
0 0 0
1 0 0
2 VAM0
0
3 VAM1
TDA9379 VM amplitude: 00ėOFF 01ė0.8V
10ė1.2V 11ė1.8V
1
4 RPO0
1
5 RPO1
Over pulse/preset pulse 00(1:1) 01(1:1.25)
10(1:1.5) 11(1:1.8)
1
6 0
0
FEA
T1
7 0
0
Notes:
ķThe option data in the above table may differ depending on models, UOC chips and CRTs
used.
ĸIt is required to check if the data comply with the function requirements of your TVs.
For example:
③For PF2720 and PF3220 models, OP1 is set to 158, OP7 to 175 and OP8 to 100 when using
TDA9375 or OP1 is set to 158, OP7 to 175 and OP8 to 100 when using TDA9379.
For PF2730 and PF3230 models, OP1 is set to 158, OP7 to 191 and OP8 to 101 when using
TDA9375 or OP1 is set to 190, OP7 to 191 and OP8 to 101 when using TDA9379.
45
To Previous Page
Loading...
