1. Safety Instructions
1.1 Transport
★Please transport the UPS system only in the original packaging (to protect against shock and
impact).
1.2 Set-up
★Condensation may occur if the UPS system is moved directly from a cold to a warm
environment. The UPS system must be absolutely dry before being installed. Please allow an
acclimatization time of at least two hours.
★Do not install the UPS system near water or in damp environments.
★Do not install the UPS system where it would be exposed to direct sunlight or near heat.
★Do not block off ventilation openings in the UPS system’s housing.
1.3 Installation
★Do not connect appliances or items of equipment which would overload the UPS system
(e.g. laser printers) to the UPS outlet socket
★Place cables in such a way that no one can step on or trip overthem.
★Do not connect domestic appliances such as hair dryers to UPS output sockets.
★The UPS can be operated by any individuals with no previous experience
◇Installation for Plus III-6KLRB / Plus III-10KLRB
★Warning: This is a product for restricted sales distribution to informed partners. Installation
restrictions or additional measures may be needed to prevent disturbances’.
★A readily accessible disconnect device shall be incorporated in the buildinginstallation
wiringand must be close to the UPS system.
★This is permanently connected equipment and only qualified maintenance personnel may
carry out installations.
To Next Page
Loading...