Apollo ADR - User Manual

Technical Support Line +44 (0)23 9244 2706 Doc 39215-410 Iss 2
Isolator Specicaon
VSO, Isolate Voltage 13-16V
VSC, Reconnect Voltage 12-14V
IC, Connuous Current—
Switch Closed
1A max
IS, Switching Current 3A max
IL, Leakage Current 300µA max
Condions for Holding
The door will hold if all the following
condions are met:
• There is loop communicaon
• The device is suciently charged (45
minutes)
• No faults on the device
• The device has a valid address (not 0 or
127)
• There is no Alarm condion indicated by
the panel
Maintenance
Fire door holders should be tested weekly as
part of the re-system test procedures. For
opmum holding force, the face of the magnet
and keeper plate should be kept clean and free
from damage. To comply with BS EN 1155, this
device should not be used to hold open a door at
less than 65°. There are no user-serviceable
parts in this door retainer.
EMC Direcve
The Addressable Door Retainer complies with
the essenal requirements of the EMC Direcve
2014/30/EU, provided that it is used as
described in this installaon guide.
Construcon Products Regulaon (EU)
305/2011
The Addressable Door Retainer complies with
the essenal requirements of the Construcon
Products Regulaon (EU) 305/2011
Technical Support Line +44 (0)23 9244 2706 Doc 39215-410 Iss 2
Addressable Door Retainer (ADR)
Product overview
Product: Addressable Door Retainer (ADR)
Part No: 55000-982APO
Digital Communicaon: XP95 compable
Product informaon
Door retainers ensure buildings are accessible for all by holding re doors in the open posion then
releasing and closing them according to the re system design. The Apollo Addressable Door Retainer
is an XP95 device designed for installaon directly onto an addressable loop and is suitable for use on
all types of re door, including crical actuaon doors.
• Integrated loop isolator
• Extra low voltage usage
• Suitable for crical actuaon (Category A) installaons*
• Failsafe by design
• Patented permanent magnet technology
• Doors and zones can be individually controlled
• 200N holding force rang
• Surface or semi-ush wall mounted
• Floor mounng opons via standard bracket
*When connected to a compliant panel
Apollo Fire Detectors Ltd
36 Brookside Road
Havant
Hampshire
PO9 1JR
Tel: +44 (0) 23 9249 2412
Fax: +44 (0) 23 9249 2754
www.apollo-re.co.uk
techsales@apollo-re.com

Apollo ADR Specifications

General

Brand	Apollo
Model	ADR
Category	Wireless Access Point
Language	English