APOLLO3D SATURN 10 - 4. Introduction of Touch Screen - Saturn10 P; Saturn10 P Ready Print and Preheat Controls; Saturn10 P Move and Extrusion Controls

12
4.Introduction of Touch Screen-Saturn10P
Ready Print
homepage
Preheat: set the extruder or heat-bed temperature.
Move: move X-axis/Y-axis-Z-axis.
Home: Printer zeroing.
Printing: select what you want to print.
Extrusion: load/ unload the filament.
Leveling: leveling the heat-bed.
Settings: Option.
More: N.A.
Preheat
Add: Set temperature up.
Des: Set temperature down.
Extruder: Set Extruder temperature.
10°C: Set heat-bed temperature.
Back: back to homepage.
Move
X+/ Y+/Z+: Increase the distance from the x-axis/y-
axis/z-axis to the origin.
X-/Y-/Z-: Reduce the distance from the the x-axis/y-
axis/z-axis to the origin.
1mm: parameters of increased or reduced.
Back: back to homepage.
Extrusion
In: load filament in to 3D printer.
OUT: unload filament.
Back: back to homepage.