Apple iPod Hi-fi - Battery Saving Tips

20 Chapter 3 Using Your iPod Hi-Fi
Pairing Your iPod Hi-Fi With the Remote
The included Apple Remote works with other compatible Apple products that have a
built-in infrared (IR) receiver. You can set your iPod Hi-Fi to work only with the included
remote so that remotes for your other devices don’t affect your iPod Hi-Fi.
You may wish to pair your other Apple Remote–compatible devices with other Apple
Remotes so that the remote you use with your iPod Hi-Fi doesn’t affect those devices.
See the documentation that came with the other devices for instructions.
To set your iPod Hi-Fi to work only with the included remote:
1 Connect your iPod Hi-Fi to an electrical outlet.
Note: If your iPod Hi-Fi has batteries, you don’t need to connect it to an outlet.
2 Make sure other products that are compatible with the remote are not in range, and
hold the remote close to your iPod Hi-Fi (about 3 to 4 inches away).
3 Press and hold the Menu and Next/Fast-forward (
‘
) buttons on the remote
simultaneously for about six seconds. The status light blinks green several times.
Your iPod Hi-Fi now works only with the paired remote.
To reset your iPod Hi-Fi to work with all Apple Remotes:
1 Connect your iPod Hi-Fi to an electrical outlet.
Note: If your iPod Hi-Fi has batteries, you don’t need to connect it to an outlet.
2 Make sure other products that are compatible with the remote are not in range, and
hold the remote close to your iPod Hi-Fi (about 3 to 4 inches away).
3 Press and hold the Menu and Play/Pause (
’
) buttons on the remote simultaneously
for about six seconds. The status light blinks green several times.
Your iPod Hi-Fi now works with all Apple Remotes.