Apple profile - Page 34

transfer rate,
you
can reconfigure
your
driver
for
the Write mode, but
you
must remember
that the
information
that
you
wnte
on the disk
is no
longer automatically verified. To
configure
your
ProFile for the Write
mode
follow
these steps.
This
procedure
assumes
you
have
already added the
.PFOFILE
driver to the SOS.DRIVER file
ol
your
boot
drskette as described earlier in thrs
seclion
In
lhe
paragraph
enlilled Adding lhe ProFrle Device
Driver".
1 . Insert the
"ProFile
Driver and SVStem Utilities
Software" diskette
into the built-in
drive and boot the Apple lll.
2.
Boot lhe Apple lll-Hold
the CONTROL key down
and
press
RESET.
3.
Type
S
for
the System Configuration Program
(SCP)
option and
you
see the
SCP
menu
on
the
screen.
4.
Type
R
for
the Read a Driver
option.
The Apple
tells
you
that
no
drivers are loaded.
5.
Remove
the
"ProFile
Driver and
System Utilìties Software"
diskette
and
insert
the boot diskette.
6.
Type
.D1/SOS.DRIVER
and
press
RETURN. A listing
of the
Current Driver
Conf
iguration
appears.
7. The
computer again asks
you
to Enter Driver File
Name. lgnore
this request
and
press
ESCAPE to
display the SCP menu.
8.
Type
E for the Edit Driver Parameters
option.
9.
Type the number
of the drrver to
be
edited,
press
RETURN, ano
Edit Driver Parametors
aopears on the screen.
'10.
Type the number
of the Conf
iguration
Block Data
option.
The
drrver
confrguralion block appears on the screen.
11.
Notice
that lhe value in byte
0
is
FF, which
is
the default
(Write/Verify)
value. To
change to the Write mode, type
00
and
PTESS
RETURN.
12. Press
ESCAPE three times to relurn to
the SCP menu. Type G to
select the Generate New
System option. The computer asks
you
to Enter Dr iver File Name.
13. Type.Dl/SOS.DR|VER
and
press
RETURN. The
computer again
asks
you
to Enter Driver File Name. lgnore
this request.
28 ProFile
Owner's Manual