Apple Time Capsule - Page 9

Chapter 1 Getting Started 9
To set up Time Capsule using a Macintosh, you need the following:
 A Macintosh computer with an AirPort or AirPort Extreme Card installed to set it up
wirelessly, or a Macintosh computer connected to your Time Capsule with an
Ethernet cable to set it up using Ethernet
 Mac OS X v10.4 or later
 AirPort Utility v5.3 or later
To set up your Time Capsule using a Windows PC, you need the following:
 A Windows PC with 300 MHz or higher processor speed and a compatible 802.11a,
802.11b, or 802.11g wireless card, or a wireless card that complies with an IEEE 802.11n
draft specification
 Windows XP Home or Professional (with Service Pack 2 installed) or Windows Vista
 AirPort Utility v5.3 or later
Plugging In Your Time Capsule
Before you plug in your Time Capsule, first connect the appropriate cables to the ports
you want to use:
 Connect the Ethernet cable that’s connected to your DSL or cable modem (if you will
connect to the Internet) to the Ethernet WAN (< ) port.
 Connect a USB cable connected from the USB (d ) port on your Time Capsule to a
compatible USB printer (if you will print to a USB printer), a hard disk, or a hub.
 Connect an Ethernet cable from any Ethernet device to the Ethernet LAN (G ) ports.
After you’ve connected the cables for all the devices you plan to use, connect the
power cord to the power port and plug your Time Capsule into a power outlet. There is
no On switch.