8
The electronic controls that are included with the air cleaner are
used to circulate air through the air cleaner, monitor filter life and
inform the user that the air is being cleaned. Users can turn on the
blower for a set period of time or adjust it so that the blower is
on, either as part of a heating/cooling call or blower only, for a set
number of minutes per hour. This requires the Air Cleaner Control
to be mounted in an accessible location, and requires 18-22 gauge
(standard thermostat cable) wires to be run between the air cleaner
components and the HVAC components.
THE AIR CLEANER CONTROL CAN BE MOUNTED:
• Option 1: near the thermostat – see pages 9-10.
• Option 2: on the air cleaner in the LED Base,
as shown in Figure 17 – see page 11.
• Option 3: near the HVAC equipment – see page 12.
Control
LED Base
INSTALL THE AIR CLEANER CONTROL
FIGURE 17 – Air Cleaner Control Mounted on the Air Cleaner
90-1349
INSTALL THE LED BASE
1. Disconnect power to the furnace or air handler at the electrical service panel.
2. Remove the cover from the LED Base.
3. Use the supplied screws to mount the LED Base to the outer housing as
shown in Figure 16.
4. Replace the cover on the LED Base.
STOP! Complete installation and checkout of the air cleaner before proceeding with installation of the controls.
FIGURE 16
90-1354
WARNING
120 Volts may cause serious injury from electrical shock. Disconnect power to the furnace/air handler before starting
installation. Leave power disconnected until installation is completed.
To Next Page
Loading...
