27
V BATT (Battery voltage)
By pressing the "M"
push button for the
second time, the
battery voltage, ex-
pressed in volt, is
indicated on the dis-
play. The recharge
system functions
properly if at 4000
rpm the battery voltage, with low beam on, is includ-
ed between 13 and 15 V. The current time appears in
the lower part of the display.
TIME (Setting the hour/minutes)
By pressing the "M"
push button for the
third time, the hour
and minutes are dis-
played.
To change the time data, proceed
as follows:
Press the "L" push button and the
number indicating the hours will
start blinking.
To increase the value, press the
"S" push button.
To set the minutes, press the "M"
push button.
To increase the value, press the
"S" push button.
Now, to store the setting of the hour
and minutes, press the central "L"
push button.
LAP (Stop-watch)
By pressing the "M"
push button for the
fourth time, the LAP
function is displayed,
which makes it pos-
sible to time each lap
with the vehicle on
the track and to store
the data in order to
be able to consult them successively.
VB AT
TEXT
TH2O
TIME
LAP
TIME
M
S
L
VB AT
TEXT
TH2O
TIME
LAP
TIME
M
S
L
VB AT
TEXT
TH2OTH2O
TIME
LAP
TIME
M
S
L
To Next Page
Loading...
Need help?
General
