EasyManua.ls Logo

AquaScape EcoWave 2000 - General Maintenance; Outer; Inner Filter Screen Cleaning; Impeller Cleaning

AquaScape EcoWave 2000
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
aquascapeinc.com
|
CAN (866) 766-3426
|
US (866) 877-6637
5
If running through winter conditions, check regularly to make sure it is functioning properly and ice is not preventing water
from reaching the pump. In the event of a power failure, the pump should be removed to prevent any freeze damage to the
pump or the piping.
If concerned about possible freeze damage, disconnect and remove the pump. Be careful not to lose the fl at rubber
washer. Clean with fresh water and store the pump in a frost-free location. If needed, use Aquascape Pump Cleaner
Maintenance Solution (#91143) to remove excessive buildup.
Winter Application
General Maintenance
Plug the pump into a GFCI-
protected outlet and enjoy
(Ex. 7).
Ex. 7
1½"
1¼"
1"
Hosetail ready for 1" tubing
1½"
1¼"
CUT
HERE
REMOVE
Hosetail ready for 1¼" tubing
1½"
CUT
HERE
REMOVE
Hosetail ready for 1½" tubing
STAINLESS STEEL
HOSE CLAMP
1½"
Kink-Free
Tubing
Installation of stainless
steel hose clamp
Ex. 6
• Outer / Inner Filter Screen Cleaning:
Gently push on the top of the outer screen to remove it from the pump. Then, unthread the inner screen from the pump
intake (Ex. 8).
Clean the fi lter screens to remove any existing debris or buildup. If needed, use Aquascape Pump Cleaner Maintenance
Solution (#91143) to remove stubborn buildup.
• Impeller Cleaning:
Remove the four screws to disconnect the water chamber cover (Ex. 9).
Remove the impeller by pulling gently (Ex. 10).
Clean the impeller and internal pump body with Aquascape Pump Cleaner Maintenance Solution (#91143), using a
sponge or soft-bristled brush.
When re-installing the impeller, be sure to align the three tabs as shown (Ex. 11).
Re-install the water chamber using the four screws. Then, replace the outer and inner screens.
NOTE: We recommend using the largest diameter of
tubing possible to achieve maximum water fl ow. If using
pipe with a larger diameter than the smallest section of the
multi-hose adapter, cut off the smaller section to avoid any
ow restriction (Ex. 6).
Ex. 9 Ex. 10
A A
B B
2
2
1
1
Ex. 11Ex. 8

Other manuals for AquaScape EcoWave 2000

Related product manuals