Optional Inlet/Outlet
Pond Water IN
Treated Water OUT
NOTE: Do not use tools
to attach the fittings.
5
www.aquascapeinc.com
|
☎
CAN 1-866-766-3426
|
☎
US 1-866-877-6637
• An optional 2-Way Flow
Control Valve (#88005) can
be used to make sure the
water flow does not exceed
the UltraKlear
®
Maximum Flow
rate. Please refer to the UltraKlear
®
Specification Chart included in
this manual for maximum flow rate
recommendations.
• AquaForce
®
Solids-Handling
Waterfall Pump is ideal for use with
the UltraKlear
®
– The AquaForce
®
pre-filter cage allows
for the pump to be
submerged directly in
the pond and improves
UV efficiency by
pre-filtering the larger
debris from reaching
the UltraKlear
®
. Other
in-pond pump makes
and models can also
be used.
• The UltraKlear
®
is designed to be located outside the
pond. We recommend placing it in a location that is easy
to hide and access for maintenance. The UltraKlear
®
can be attached to a board and set on level ground or
mounted using the four screw holes in the support saddles
as shown here.
• The UltraKlear
®
includes three plumbing ports:
- In – Pipe from pump (Can use either end port
as pond water “In”).
- Out – Pipe back to pond (Use opposite end
port for discharge back to pond).
- Optional Inlet/Outlet to assist with installation
and pipe routing.
AquaForce
®
Pond Pump
2-Way Flow Control Valve
UltraKlear
®
with Rotational Ball
fittings and Multi-Hose Adapters
Multi-Hose Adapters mounted
directly to UltraKlear
®
Rotational Ball fittings
• The 90º elbow fittings and Locking Rotational Ball fittings
allow 360º directional movement to accommodate the
plumbing configuration desired or the Multi-Hose Adapters
can be mounted directly onto the UltraKlear
®
fixture as
shown below.
• Fittings should be hand-
tightened only and be
installed with the flat
rubber gaskets to achieve
leak-free seals.
To Next Page
Loading...
