1½”
1¼”
1”
¾”
1½”
1¼”
1”
remove
cut here
cut here
1½”
1¼”
remove
cut here
1½”
remove
Hosetail ready for ¾” tubing
Hosetail ready for 1¼” tubing
Hosetail ready for 1” tubing
Hosetail ready for 1½” tubing
6
☎
US 1-866-877-6637
|
☎
CAN 1-866-766-3426
|
www.aquascapeinc.com
• Select the Multi-Hose Adapter based on the diameter of
the tubing you are using. It is recommended to use as
large of a diameter of tubing as possible (up to 1 ½ inch
diameter) in order to achieve maximum water flows.
• If using a diameter pipe larger than the smallest section
of the Multi-Hose Adapter, trim off the smaller sections to
avoid any flow restriction.
• We recommend using a hose clamp (not included)
to secure tubing onto the fitting.
• After connecting the plumbing plug the pump and the
UltraKlear
®
fixture to an outlet that is protected by a
ground fault interrupter (GFI). Once the pump is running
and water is circulating through the UltraKlear
®
fixture,
check for any fitting leaks where the external connections
Installation of stainless steel hose clamp
stainless steel
hose clamp
1½”
Kink-Free
Tubing
are made. Since the filter is located outside the pond
even a small leak must be corrected. Check the UV
indicator to confirm that the UV light is “On” inside the
UltraKlear
®
fixture.
To Next Page
Loading...
