AQUASTRONG AQUA Series User Manual

• R

  Robin BeckAug 14, 2025

  What to do if my AQUASTRONG Water Pump motor runs but does not produce water?

  

  Same questionReply

  • Q

    qgrossAug 14, 2025

    If the AQUASTRONG Water Pump motor runs but no water is produced, several issues could be the cause. First, the pump may be rotating in the wrong direction; if it is a three-phase motor, swap the leads of two phases. Ensure the pump is filled with water. Check if the water level is lower than the bottom valve and, if so, adjust the inlet pipe to immerse the bottom valve. Also, inspect the suction pipe for any leakage at the joints. If the water level is too low, adjust the pump installation height or choose a more suitable pump. Finally, check for freezing in the pipeline or pump chamber; if frozen, start the pump after the ice melts. If none of these resolve the issue, the impeller may be damaged and need replacement.

    

    Reply
• P

  Pamela CoxAug 17, 2025

  Why is there insufficient pressure in my AQUASTRONG AQUA?

  

  Same questionReply

  • D

    Devin AyalaAug 17, 2025

    If your AQUASTRONG Water Pump has insufficient pressure, consider these possible causes and solutions: * The pump model may be incorrect; choose an appropriate pump. * The inlet pipe may be too long or have too many turns; select pipes of the specified diameter and shorten the inlet pipeline as much as possible. * There might be foreign matter blocking the intersection pipe, filter, or pump chamber; cleanse the pipeline, bottom valve, or pump chamber to eliminate any obstructions. * The motor voltage may be too low, or the wire too long; check the end voltage of the motor and the length of the wire.

    

    Reply

AQUASTRONG AQUA Series Specifications

General

Brand	AQUASTRONG
Model	AQUA Series
Category	Water Pump
Language	English