Considerable effort should be made to monitor the system where the AntiCa
++
device is
installed. On older systems where scaling took place before the AntiCa
++
device installation, the
treated water softens the scaling and in time may restore the system to its original state.
Depending on the severity of system scaling, the loose scale in piping systems with reduced flow
velocity can settle in any place and invoke system blockage. Therefore flushing of the system
must take place. Install dirt pockets with valves to drains in piping if this was not done in the
original installation.
Closed systems with low pressure and low flow should be flushed regularly till the sediments are
not visible in flushed water. Aragonite crystals could in this environment produce sediment like
powder dissolved in water, thus flushing of the system must take place to remove them.
To Next Page
Loading...