16
BENDING THE STAYS
WARNING! Do not bend the stays near the
RotoGlide™ rail. All adjustments to the stays
must be made above the first 12 cm (4.75 in)
from the bottom of the backpack.
To bend the stays:
1. Identify exactly where along the back panel
you feel discomfort, and mark the spot on
the back panel.
2. Apply gentle, steady pressure to the back
panel to bend the aluminum stays.
3. Load your pack and take a 30-minute
test walk.
If the discomfort remains, repeat steps 1-3 until
you find the best shape for your back.
To Next Page
Loading...