E-17
English
basic operation
Operating your Solo
Introduction
This section explains the basic opration of
the Solo. Note that it may be necessary to
configure the Solo correctly for optimum
performance. Details regarding system
setttings can be found in “settings menu”
on page E-28.
Switching on
Switch the unit on by pressing the power
button. The status LED glows green when
the unit is powered up. If the power
button is pressed (or power is removed)
whilst in standby, the unit will enter
standby mode when power is re-applied.
Standby
The Solo has a standby mode which can
be entered by pressing 2 on the remote
control. When in standby mode, the
display is blank and the POWER LED glows
red.
If the unit is to be left unused for an
extended period, we recommend that you
disconnect it from the mains supply to
save power.
To switch on from standby, press the 2
button on the remote control.
Home screen
Press the button at any time to display
the Solo home screen. The home screen
will allow you to access the following:
Start playing a CD/DVD/
BD disc. See “playing a
disc” on page E-25.
Allows you to play
multimedia files. See
“network/usb operation”
on page E-26.
Access the Solo settings
options. See “settings
menu” on page E-28.
Allows the selection of
various inputs of the Solo
Selecting a source
To select a particular source, press
the INPUT- or INPUT+ buttons on the
front panel until that source is shown
on the front panel display, or press the
corresponding source button on the
remote (see “Device mode / Source keys”
on page E-19).
The following sources are available:
RADIO Internal DAB/FM tuner
BT Internal Bluetooth input
MEDIA
Network input (e.g UPnP
devices), USB solid-state
device (e.g. pen drive) input
DISC Internal disc player
AV Audio-Visual HDMI input
SAT Satellite HDMI input
PVR
Personal Video Recorder
HDMI input
GAME Game console HDMI input
LINE
Phono jack analogue audio
input
AUX 3.5mm analogue audio input
STB
Set Top Box coaxial digital
audio input
TV TV optical audio input
A particular input source can also be
selected using the source option from the
home screen, as described in the previous
section.
Volume control
The volume can be increased or decreased
either by turning the top panel rotary
control (see “Top panel controls” on page
E-9) or by using the volume control
button on the remote control (see “Volume
control” on page E-19).
Headphones
To use headphones with the Solo, plug the
headphones into the phones socket on
the front panel.
When headphones are plugged into the
front panel phones socket, the speaker
and sub outputs are muted and the audio
will be down-mixed to two channels (2.0).
To Next Page
Loading...
