Arcam Solo movie 2.1 - Page 31

E-31
English
Ethernet
WiFi
Settings Menu
Network
Network
Network Standby
Network Standby
[select option]
DNLA
Enable
Proxy
[select option]
B C
B C
B C
B C
B C
B
C
B
C
B
C
OK
E
D
Network
Network Setup
Network
Network Information
Network
DLNA
Network
Proxy
Network
Net Test
Select Interface
[select option]
E
D
E
D
E
D
E
D
None
WEP
WPA-PSK(TKIP)
WPA2-PSK(AES)
WPA/2-PSK(AUTO)
Enter IP
Enter Subnet
Enter Gateway
Enter DNS1
Enter DNS2
Enable
Disable
Enable
Disable
Proxy Host
Proxy Port
Manual Input
Scan
DCHP On
(Auto)
DCHP Off
(Manual)
Select SSID
Enter Password
Enter SSID
Security
Connection Type
SSID
BSSID
Signal Strength
Channel
Security
Address Type
IP Address
Subnet Mask
Default Gateway
DNS1
DNS2
administrator. Press OK to save the setting
Subnet Mask – Use the cursors to navigate
between segments and use the 09 keys
on the remote to enter the subnet mask of
your network. Press OK to save the setting.
Default Gateway – Use the cursors to
navigate between segments and use
the 09 keys on the remote to enter the
Internet gateway address. Press OK to save
the setting.
DNS1 – Use the cursors to navigate
between segments and use the 09 keys
on the remotel to enter the IP address of
your Primary DNS server. Press OK to save
the setting.
DNS2 – Use the cursors to navigate
between segments and use the 09 keys
on the remote to enter the IP address of
your Secondary DNS server. Press OK to
save the setting.
BD-Live Connection – To set the BD-Live
Internet access level.
The access levels are:
< Permitted: All BD-Live discs are
allowed access to BD-Live websites.
< Partial Permitted: Allows Internet
access to BD-Live content with valid
certificates only.
< Prohibited: Prohibit all BD-Live discs
from accessing BD-Live websites.
NOTE
< The available on-line functions are
disc-dependent.
< Refer to the BD-Live disc
instructions for information about
accessing on-line content.
< The Solo must be connected to
the Internet and set up correctly
to allow access to on-line content.
See “Network connection” on page
E-13 for network connections
and “Network” on page E-30 for
network settings.
/
Proxy Setting – If you are accessing the
network using a proxy server, enter its
settings here.
Network settings diagram applies to