Archos Citee Power - Page 13

13
english
Note: Wrap the pointed end of the crowbar with ber cloth so that it will not damage the inner tire and coating of the
hub.
Install the inner and outer tires
2
0
60
40
80
P S I
1
0
0
120
20
60
40
80
P
S I
100
120
1
2
3 4
1. Fill a small amount of air into the deated inner tire till the inner tire is just bulged to look round.
2. Put the hub on the top of a desk. Pay attention to the direction when installing the outer tire. There is an arrow on the outer tire, and it
must be consistent with the forward direction of the wheel. Use one hand to hold the hub, and use the other hand to insert one side of the
outer tire in the hub groove.
3. Insert the air valve of the inner tire into the air valve hole. Insert the inner tire in the outer tire clockwise and in sequence. Make sure that
the air valve does not tilt. Then, insert the other side of the outer tire in the hub groove. Finally use a crowbar to install the remaining tire lips
in the hub groove. After installation, pinch the outer tire to check if the inner tire is pressed by the tire lips of outer tire.
4. Inate the inner tire to 15-20 PSI, and check the safety lines at two sides of the outer tire. Make sure that the distances from the safety lines
to the hub edge are consistent.
5. Finally inate the inner tire to 45-50 PSI. Tighten the air valve cap. Then, the tire assembly is completed.
Note: Wrap the pointed end of the crowbar with ber cloth so that it will not damage the inner tire and coating of the hub.