Operation
11
AUTO-RESTART
IIn the event of an unexpected power outage, the unit will automatically restart with the previous
settings when the power resumes.
WAIT 3 MINUTES BEFORE RESUMING OPERATION
After the unit has stopped, it can not be restarted for the first 3 minutes. This is to protect the
unit. Operation will automatically start after 3 minutes.
AIR FLOW DIRECTION ADJUSTMENT
Adjust the air flow direction manually:
-The louvers can be set to the desired position manually.
-Do not place any heavy objects or other loads on the louvers, doing so will cause damage to
the unit.
-Ensure the louvers are fully opened under heating operation.
-Keep the louvers fully opened during operation.
Water drainage
-Under dehumidifying modes, remove the drain plug from the back of the unit, install the drain
connector(5/8" universal female mender) with 3/4" hose (sold separately). For the models
without drain connector, just attach the drain hose to the hole. Place the open end of the hose
directly over the drain area in your basement floor.
Remove the
drain plug
Continuous
drain hose
-When the water level of the bottom tray
reaches a predetermined level, the unit beeps 8 times, the
digital display area shows "P1" . At this time the air
conditioning/dehumidification process will immediately stop.
However, the fan motor will continue to operate (this is normal).
Carefully move the unit to a drain location, remove the bottom
drain plug and let the water drain away. Reinstall the bottom
drain plug and restart the machine until the "P1" symbol
disappears. If the error repeats, call for service.
Bottom drain
plug
NOTE:When the continuous drain hose is not used, ensure that the drain plug and
knob are installed firmly in the air conditioner to prevent leakage.
NOTE: Be sure to reinstall the bottom drain plug firmly to
prevent leakage before using the unit.
To Next Page
Loading...
