Installation Instructions
Installing the Unit in a Sliding Window
11
8 "
11
16
1.Attach the support brace to platform as shown.
Use the adjustment bolt and hex flange nut to
complete the assembly. Choose slot and adjustment
bolt hole locations that will create a 45-degree angle
between the platform support brace. Fit the assembly
in the window to determine if the platform will rest
properly,and allow a allow proper slope (3/16-inch
lower on the outside).
lf you are planning to use a siding
protection board (refer to Step 5) on the outside of
your house, hold the board in place when testing
the assembly in window.
Property damage hazard-Failure to comply with
the following precautions could result in
damage to the window or air conditioner.
2.Measure,and lightly mark a line 8-11/16"
3. Center the platform assembly with the inside
platform tab pressed against the inside adge of
window track. Using the holes in the platform as
a guide, mark and drill two 9/64" diameter holes.
Drill holes in the track or stool.
Choose the proper window location.
Center the platform
assembly with the
platform tab pressed
against the inside
edge of the window
track.
Choose a window that allows the cooled air to flow
freely and directly into room(s) you wish to cool.
Remember that it is difficult to move air around
corners. Also choose a window that is within 6 feet
of an electrical outlet (refer to "Meeting Electrical
Requirements/Receptacle Wiring Needs" section).
Do not use an extension cord.
from the window jamb.
"
(6 mm) hex flange nut
Alternate screw location
(depending on the stool depth)
Platform tab
Window track Window sea1
assembly
the
subframes
To Next Page
Loading...
