Installation Instructions
Installing the Unit in a Casement Window
15
1.Attach the support brace to the platform as
shown on the right. Use the adjustment bolt
and hex flange nut to complete the assembly.
Choose the slot and adjustment bolt hole
locations that will create a 45-degree andle
between the platform and support brace. angle
assembly in the window to determine if the
platform will rest properly and allow a proper
slope (3/16-inch lower on the outside).
2.Drill a 9/64-inch diameter pilot hole
at an
3/16 inches
3.Peel off the protective backing
Platform assembly
the track
1/4-in. (6 mm) hex flange nut
outside edge of the bottom window jamb
4.Screw the paltform assembly to the window
aligns
jamb
two-glass
.
To Next Page
Loading...
