When the unit is ON or OFF, first press the TIMER button. The TIMER ON indicator light will illuminate,
indicating that the AUTO-START program has been initiated.
When the TIMER ON time is displayed, press the TIMER button again. The TIMER OFF indicator light
will illuminate, indicating that the AUTO-STOP program has been initiated.
Press or hold the UP or DOWN button to change the AUTO time in 0.5-hour increments, up to 10 hours,
then 1-hour increments up to 24 hours. The control will count down the remaining time until start.
AUTO/ STRAT/ STOP timed program.
MODE Button
TIMER Button
CHECK FILTER Button
When you set the air conditioner in AUTO mode, it will automatically select COOL, HEAT (on some
models only), or FAN ONLY operation depending on the temperature you have selected and the
room temperature.
The air conditioner will automatically control the room temperature around the temperature point set
by you.
To operate on DRY mode:
In this mode, the air conditioner will operate as a dehumidifier. Since the conditioned space is a closed or
sealed area, there will still be some degree of cooling.
Operating Instructions
7
To choose the operating mode, press the MODE button. At each button press, a mode is selected in a
sequence that goes from AUTO, COOL DRY and FAN. The indicator light will illuminate and remain
ON once the mode is selected.
To operate on AUTO mode:
To operate on FAN ONLY mode:
In FAN ONLY mode, the temperature cannot be adjusted.
This feature is a reminder to clean air filter for more efficient operation. The LED light will illuminate after
250 hours of operation. To reset after cleaning the filter. press the CHECK FILTER button and the light
will go OFF.
To Next Page
Loading...
