Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Pre-operation
1. Before using your Arctic fridge/freezer for the first time, clean entire fridge/freezer inside
and out with a damp cloth.
2. To use AC adapter, plug AC adapter into AC outlet. Plug the lighter socket from the
fridge/freezer power cord into the AC adapter.
3. If connecting to a 12 volt outlet. Make sure circuit is in good condition and has the correct
capacity to power the fridge/freezer. 15 AMP or higher rating on socket is recommended.
4. If using a solar power supply,
5. If connecting to 120V AC off a portable generator, it must be equipped with an automatic
voltage regulator and the power supplied by the generator must be a pure sine wave AC
voltage.
CAUTION – Some generators will not produce output power that is compatible with the
fridge/freezer. This is common for conventional style generators. Inverter generators like
the Smittybilt EPS generator will have the pure sine wave output that is compatible with the
Arctic fridge/freezer.
General installation
A minimum clearance of 4” must be maintained on all sides of the fridge freezer.
Fridge freezer must be securely attached to its mounting location to prevent unwanted
movement.
Never operate near flammable vapors, liquids, or objects.
Ideal location for the fridge/freezer is on a flat surface.
The carry handles can be used as a tie down point or you can use the integrated tie down
points on the included insulated cover.
If using a 12 volt extension, follow the wire size guide to determine the thickness of wire
needed for your length of wire being used. If hardwiring fridge/freezer, use wiring size chart
and install a 15 Amp inline fuse into the circuit.
To Next Page
Loading...