7
GB
Technical informations
(pag.2)
Technical data indicated on the appliance.
Batteries
The remote control is supplied with CR2025 3V batteries; remove the
protective plastic from the battery compartment of the remote control
before use.
When the battery has run out, it must be replaced with another one of
the same type.
To remove the battery, refer to the diagram shown on the back of the
remote control:
GB
Instructions for use
1 – Air outlet grid
2 - Display
3 - Base
4 - Air inlet grid
5 - Button / Indicator light:
“TEMPERATURE”
6 - Button / Indicator light:
“TIMER”
7 - Button / Indicator light:
“SWING”
8 - Button / Indicator light: ON/
OFF
Description of controls:
To turn the appliance on, insert the plug in the power outlet.
For your convenience the unit can be operated by using control panel in
the main body or using remote control included.
“On/O” button (control panel)
- When the device is switched o, press this button to turn it on. The
device switches on in minimum heating mode.
The indicator light (8) will switch on in blue colour and the display (2)
shows the room temperature.
- When the device is switched on, press this button to change the
operating mode:
- minimum heating; indicator (8) will be blue;
- maximum heating; indicator (8) will be red;
- o; indicator (8) will be switched o. Wait 15 seconds until the fan
will stop.
16
Elemek
A vezérlők leírása:
„Be/Ki” gomb (vezérlőpanel)
Várjon 15 másodpercet, amíg a ventilátor
leáll.
To Next Page
Loading...
