10 / 12
1. Handle
2. Air-outlet grid
3. ON/OFF and SPEED switch
4. USB socket
5. Lever for vertical tilt
6. Cover of the battery compartment
(IT) Instructions for use
Batteries
The fan is supplied with battery inside (type 18650 Li-ion 3,7V 2000mAh).
When the battery is over, it must be replaced with the same type.
DO NOT USE OTHER KINDS OF BATTERIES!
Switch off the appliance and disconnect the USB cable before installing or removing
the battery.
To remove battery:
1. Make sure that the battery is fully discharged;
2. Open the cover of the battery compartment (6);
3. Remove the battery;
4. Dispose the battery as described it the DISPOSAL section.
To install the battery, insert it with the correct polarity showed on the battery compartment.
Battery charging
To charge the battery, connect the USB socket (4) of the fan to a USB port.
To use the fan
Disconnect the USB cable.
Place and use the device on a horizontal and stable surface.
Push the button (3) to switch on the fan, to change the speed and to switch off the fan.
Each time you push the button (3), the fan change its working mode as follow:
- Low speed
- Medium speed
- Maximum speed
- Off
Use the lever (5) to adjust the vertical tilt of the fan.
Switch off the fan after use.
(EN) MAINTENANCE
Before carrying out the regular cleaning operations turn off the fan and unplug it.
DO NOT disassemble the fan: this fan cannot be disassembled.
For external cleaning use a soft and dry cloth.
DO NOT dip the device in water, or splash it with any other liquids.
DO NOT use solvents or any other chemical products for cleaning it.
When you do not use it, after cleaning it, store the fan in a dry place.
To Next Page
Loading...
