ARDES AR5T75 - Page 14

14
Instructions for use
Assembly.
Caution! The fan should always be switched off and does not connected
to the mains supply, if you mounting the fan.
- To fix the base to the body fan, set the fan gently on the head. Use a soft
surface to not damage the top of the product.
- Unscrew the plastic nut from the bottom by turning it anticlockwise
- Fix together the two half of the base on the bottom of the fan
- Screw up the plstic nut to fix the base on the bottom of the fan by turning
it clockwise.
- Fix the cable with the preassembled strain relief as showed in the
picture below (picture number 1).
Picture 1
Pay attention that all the parts are correct and firmly connected with each
other.
Caution! Connect to the mains supply only after the fan has been fully
assembled.
- The fan must not be used without a fixed base
- The device may be operated only in straight and upright position
- This device may not be used in a horizontal position
Before plug the product check if it is switched Off. Insert the plug of the
fan into a suitable socket outlet. Set the speed/oscillation using the knob
as below:
1 = low speed
2 = middle speed
3 = high speed
0 = off
1
< >
= low speed with oscillation
2
< >
= middle speed with oscillation
3
< >
= high speed with oscillation