15
INSTRUCTIONS FOR USE
Assembly.
Caution! The fan should always be switched o and does not connected
to the mains supply, if you mounting the fan.
- Unscrew the nut from the bottom of the fan unit (picture number 1).
- Guide the cable through the centre of the two base plastes then push
the two plates together (picture number 2).
- Place the fan unit on top of the base (picture number 3).
- Secure the base with the nut (picture number 4) and guide the cable
tightly through the groove in the outer rim of the base (picture number
5).
Pay attention that all the parts are correct and rmly connected with each
other.
Caution! Connect to the mains supply only after the fan has been fully
assembled.
- The fan must not be used without a xed base
- The device may be operated only in straight and upright position
- This device may not be used in a horizontal position
4 5
1 2 3
To Next Page
Loading...
