27
When the ambient temperature reaches the set temperature,the heating
wire turns o and the unit will work in fan mode for 10 seconds then enter
in standby mode.
When the ambient temperature drops 2°C below the set temperature, the
unit will turn on again according to the latest setting.
Press Timer / Temperature button two times to set the timer as explained
above in fan mode.
HEATING Button (F)
When the unit is on, press this button once to activate heating function
(low power); the related indicator light will turn on in the control panel.
Press this button again to select the maximum power; the related
indicator light will turn on in the control panel.
Press this button again to activate ECO mode (the related indicator light
will turn on in the control panel). In ECO mode the display will turn o
(is not possible set the desired temperature). In ECO mode the default
setting temperature are 25°C and 18°C (they can’t be changed).
When the ambient temperature is lower than 18°C, the unit will work
automatically at maximum heating power level. When the ambient
temperature is equal to or greater than 18°C and lower than 25°C, the unit
will work automatically at lower heating power level. When the ambient
temperature is equal to or greater than 25°C the unit enter in stand-by
mode and will turn on again when the ambient temperature drops about
2°C lower than the set temperature (about 23°C).
NOTE: in heating mode you can’t select the air speed.
NOTE: to switch in fan mode it’s necessary deactivate ECO mode
function by pressing heating button.
DISPLAY OFF button (G)
Press this button when the unit is on to turn the indicator lights and
display o. Press again to turn them on.
NOTE: the appliance is equipped with a shut-o switch if it accidentally
tips over.
To Next Page
Loading...