Areca ARC-5020-3 - Turn off and Shut Down Computer; Open the Mac Pro Case; Remove Drive Carriers

4 pages

To Next Page

To Previous Page

ARC-5020-3 Installation instructions for MacPro

1. Turn off / Shut Down your computer

Touch the metal on the outside of your MAC Pro

(Chassis) while it’s still plugged in to discharge any

static electricity from your body.

Then Turn off the

system. When the system is completely shut down,

unplug the power cord of the Mac Pro.

2. Open the Mac Pro Case

Lift the rear latch to unlock the side panel.

Caution - The internal components can still

be very hot after the system has been shut down.

Allow the system to cool down if needed.

Open side panel by pulling away from the case,

then lift up to remove. Set side panel aside.

3. Remove the drive carriers

Make sure the latch on the back panel is still open, then pull out

empty drive carriers 2, 3 and 4 and set them aside.

PAGE 1