A&E Specification AV5585PM Rev. 061616
425 E. Colorado Street, 7
th
Floor (818) 937-0700 Page 2
Glendale, CA 91205 www.arecontvision.com
d) FCC Standard Compliance:
Title 47, Part 15 (47 CFR 15) Subpart B Class A
e) Mechanical Standards:
ANSI/IEC 60529-2004 - IP66 dust/water Ingress protection rating
EN62262:2002 – IK-10 impact rating
f) Video Compression Technology
H.264 MPEG-4, Part 10 ISO/IEC 14496-10 AVC
g) Networking Standard:
IEEE 802.3af-2003 PoE Standard, Class 3
IPv4
h) Country of Origin
FTC “Made in USA” standard compliant
Part 2 Products
2.1 Manufacturer
Arecont Vision, LLC
425 E. Colorado St. #700
Glendale, CA 91205
Phone: 818-937-0700
877-226-3728
Fax: 818-937-0464
www.arecontvision.com
2.2 General
The AV5585PM SurroundVideo® G5 Stellar network camera is part of Arecont Vision’s full line of H.264
SurroundVideo® cameras. STELLAR™ low light technology reduces motion blur, noise and storage requirements,
while enhancing contrast and allowing color imaging in near complete darkness. This fully compliant
implementation of H.264 (MPEG 4, Part 10) provides an all-in-one solution with four integrated 1.2-Meapixel
resolution at full video frame rates of 12fps. With the features of remote focus, P-iris control, unlimited privacy
masking, extended motion detection and flexible cropping, the AV5585PM is a high sensitivity, PoE (IEEE 802.3af)
compliant true Day/Night camera. Built with Arecont Vision® massively-parallel MegaVideo® processing
technology, this camera offers more than fifteen times the resolution of standard resolution IP cameras with the
ability to output full real-time frame rates and deliver the high quality megapixel imaging for indoor and outdoor
applications.
2.3 Hardware
The camera shall utilize four high sensitivity 1.2-Megapixel CMOS sensors with 1/3” optical format,
3.75um x 3.75um pixel size, progressive scan and Active Pixel Count: 1280(H) x 960(V) pixel array
The camera shall integrate four 5.6mm RF/P-iris CS Mount megapixel IR corrected lenses, 1/3”, F1.2 - 1.8,
Horizontal Field of View of 47°.
The camera’s power source shall be Power over Ethernet (PoE) complying with the IEEE 802.3af standard.
The camera shall have an auxiliary power input, 24VAC and 18-48V.
The camera shall have die-cast aluminum chassis with IK-10 vandal resistant dome. Entire enclosure to be
rated minimum IP66 for water and dust protection.
To Next Page
Loading...
Need help?
General