www.argonaudio.com
D A B a d a p t e r 3 m k 2 Q u i c k s t a r t
Quick start
Start up
1. Connect the Antenna and place it in a position
that allows optimal reception of stations.
2. Plug the Power supply into an electric outlet and
into the back of the Adapter.
3. The Adapter will start searching for DAB stations
automatically. This may take a few minutes and
the progress will be shown in the display.
4. Once finished searching, the Adapter will start
playing the first found station.
Basic Operating
1. Notice; All operations on the Adapter are done via
the remote control.
2. Stations can be chosen by pressing the “arrows”.
3. Once the prefer station is found press the “select”
button and the chosen station will start playing.
4. To store a station on one of the 1-6 preset
buttons, press and hold the wished preset button
for 3 sec., while playing the station that you want
to store.
5. When stored, the display will show “Preset X
saved”
6. To tune stations press and hold the “autotune”
button for 3 sec. and the Adapter will scan for
available stations..
Other Operating functions
1. Sleep function is activated by pressing the
“Sleep” button and the display will indicate “Set
Sleep time”. Press the “Sleep” button to select the
sleep time period. Confirm by pressing the
“Select” button.
2. Alarm function is activated by pressing the “Alarm”
button and the display will indicate “Alarm 1 setup”.
Press the “Select” button to select ON mode. Use the
arrow buttons to choose your settings. Once a setting
is made, confirm by pressing “Select” button.
Continue the same way with the other settings, such
as alarm sound source, alarm level, daily/week-end
etc. After about 10 sec. the display will return to main
display by itself. Activated alarm will be indicated at
the bottom of the display by a small clock icon.
3. Pressing the “Snooze/Mute” button will terminate
and/or activate the sound
4. The “Info” button will show different display
information upon pressing it continuously.
5. Pressing the “Menu” button will bring you into the
Adapters menu settings. Use the “arrows” to scroll
through the “Menu” options. Use the “Select” button
to enter the wanted “Menu” setting.
To Previous Page
Loading...