FRIDGE FREEZER | USER MANUAL Customer Helpline 0845 600 4632 3
Electrical safety
WARNING! IMPORTANT!
DO NOT connect your appliance to the electricity supply until all packaging and transit protectors
have been removed.
Electrical safety is only guaranteed when the earth system of your house is
in accordance with the related local regulations.
Check the voltage of this unit corresponds with your house electricity supply. If the socket
outlets in your home are not suitable for the plug supplied with this unit check with a qualified
electrician for replacement.
Do not use an extension cable/cord or multi adaptors.
This appliance must be positioned so that the plug is accessible.
Do not damage the refrigerant circuit.
Do not bend, stretch or pull the supply cable to avoid electric shock
Do not use electrical appliances inside the food storage compartments of the appliance, unless
they are of the type recommended by the manufacturer.
If power supply cord is damaged, it must replaced by the manufacturer or its service agent or a
similar qualified person in order to avoid a hazard.
Installation Instructions
Transportation
The appliance must be handled and installed by two or more persons.
The appliance should be transported only in an upright position. Do not tilt the appliance
greater than 45°. The packing as supplied must be intact during transportation.
After transporting the appliance, leave it for at least 4 hours before switching on to allow the
cooling system to settle. Failure to comply could result in damage to the appliance.
Do not move the appliance by pulling the door or handle as it may damage your flooring and
wall coverings etc.
Empty any water in the drain tray before moving.
Make sure that the defrost water pipe at the back of the product is fixed to the plastic
evaporating pan on the top of the compressor, to avoid defrost water spillage on the floor.
Ensure the supply cable is not caught under the appliance during and after moving.
Installation
Ensure sufficient spacing is provided for the appliance to be installed. Leave space on both
sides (15cm), back (20cm) and above the appliance (30cm) to ensure proper ventilation.
To Next Page
Loading...
