FRIDGE FREEZER | USER MANUAL Customer Helpline 0845 600 4632 9
Remove all the food if you are away for three weeks or more. Unplug the appliance and leave the
doors open to provide air circulation to prevent odour and mould.
Moving
Refer to section “Transportation” under “Installation instructions”
Electrical Connection
An electric supply of 220-240 volts AC only, 50Hz is required. Make sure that a suitable electrical
supply socket is located close to where the appliance is to be placed.
For your personal safety, the appliance must be earthed.
The appliance is equipped with a
power supply cord having a 3-pin grounding plug. To minimize possible shock hazards it must be
plugged into a matching 3-pin grounding type electrical outlet. If the mains plug is unsuitable for
the socket outlet in your home or is removed for any other reason, then the cut off plug should be
disposed of safety to prevent the hazard of electric shock.
Connection to power
Before switching on, make sure that the voltage of your electricity supply is the same as that
indicated on the rating plate.
Main Cord
This appliance may be fitted with a non-rewirable plug.
If it is necessary to change the fuse in a non-rewirable plug the fuse cover must be refitted. If
the fuse cover is lost or damaged, the plug must not be used until a replacement is obtained.
It is important that the colour of the replacement fuse cover corresponds with the colour
marking on the base of the plug.
If the plug has to be changed because it is not suitable for your socket, or becomes damaged,
it should be cut off and an appropriate plug fitted following the wiring instructions below.
The plug removed must be disposed of safely as insertion into a 13A socket is likely to cause
an electrical hazard. For your own safety read the following instructions carefully.
Before attempting to connect this unit to mains. The wires in this mains lead are coloured in
accordance with the following code:
BLUE = NEUTRAL
BROWN = LIVE
GREEN+YELLOW = EARTH
IMPORTANT!
As the colours of the wire in the mains lead of this appliance may not correspond with the
coloured markings identifying the terminals in your plug, proceed as following:
The wire which is coloured blue must be connected to the terminal which is marked with
the letter N or coloured black.
The wire which is coloured brown must be connected to the terminal which is marked with
the letter L or coloured red.
The wire which is coloured green and yellow must be connected to the earth terminal which
is marked with the letter E or coloured green and yellow.
To Next Page
Loading...
