Argus C3 - Page 15

--
moke
sure theeccentricshoulder
on the beoring
possesihrough
the hole in the bell
cronk. While
tightening
the
screw, check
to ossure thot the bell
cronk
pivots freely.
lnsert
the releose
plungerossembly
through its
holeot the
top
of the comero
--
the elongoted
slot in the.
releose
plunger
(which
receives the bross
pin
screw) must be
to the
front of the comero.
Then,
reploce the
bross
pin screw from
the front of the
comero.
The releose
plunger should now
rotole f reely between
the
"B"
ond
"l"
positions
--
remember, the boll detent
ond spring hold
the
releose
plunger
ot either
setting. Ploce
first the
boll detent,
ond then the spring, into thecovityottheendof
thecomero body.
Then,
tighten the
setscrew
unti
l you feel the
two
sol
id
"cl
ick-stop"
positions
of the releose
plunger.
Before
replocing
the
moin
lever ond
shuttlecock ossembly,
exomine the
ioint
between the
shuttlecock
ribbon ond the moin
lever,
Fig.
22.
You
con seethot theshuttlecockribbon
issoldered
within
q
slot
in the body
of the moin lever.
Replocing o
broken
shuttlecock ribbon is
one of
your
more
common repoirs in the
Argus C-3.
BODY
OF
MAIN
LEVER
SHUTTLECOCK
RIBBON
SOLDER
JOINT
r:T
-i
FIGURE
22
UNDERSIDE
OF MAIN
LEVER
Hondle the
shuttlecock ribbon very corefully
os you lower
the moin lever into
position. Accidentolly
plocing o
kink in
the
shuttlecock ribbon
could couse
the metol to
foil
during
the
shutfer
operotion.
When the
ossembly is fully seoted, reploce
fhe
moin
lever retoining
screw ond hook the end of themoinspring
over its
post.
Test the movement
of
the
moin
lever
bycocking
ond
releosing
the shutter
severol times.
Hook the
end of the bell
cronk
spring
over the
post on the
comero
body. Now,
cock the
shutter ond seot the speedsescope-
16
UNDERSIDE
OF MAIN
LEVER