© e2v technologies (uk) limited 2012 Document subject to disclaimer on page 1 A1A-xxxxxx Version x, page 2
CAMERA SPECIFICATION
Environmental Data
Thermal conditions - The camera has been designed to operate:
continuously between –10 C (14 F) and +80 C (176 F) or
150 C (300 F) for 15 minutes
260 C (500 F) for 5 minutes
Sealing - IP67, will withstand short-term immersion in water
Impact - The camera will withstand a drop from a height of 2 metres (78 inches) onto concrete
Storage - It is recommended that for maximum effective operational life, the storage temperature is
kept between -10 C and +40 C (14 F and 104 F)
Optical Data
Detector
Sensor type - Uncooled Microbolometer
Sensor material - Amorphous Silicon (ASi)
Resolution - MI-160 : 160 x 120 pixels; MI-320 : 320 x 240 pixels
Pixel size -
25
Spectral response -
8 – 14 m
MDTD -
70 mK (0.07 C) typical (Minimum Discernible Temperature Difference)
Dynamic range -
-40 C to 800 C (-40 F to 1472 F) via 3 ranges with auto-switching.
Refresh rate - 120Hz for 160 sensor, 60 Hz for 320x240 sensor
Spot temperature range -
0 C to 800 C (32 F to 1472 F)
Lens
Lens material - Germanium
Focal distance - 1 m to infinity, optimized at 4 m (3 feet to infinity, optimized at 13 feet)
Aperture - f/1.0
Field of view -
50 horizontal, 37.5 vertical
Display
Type - High grade, Industrial, color TFT active matrix LCD
Size - 69 mm (2.7 inches)
Pixel format - QVGA 320 x 240, (each pixel RGB format, total pixels 230,400 pixels)
Video input - Sensor synchronized direct digital drive
Backlight - 400cd/m
2
Mechanical Data
Camera dimensions (H x W x D) - 200 mm x 88 mm x 85 mm (without Picatinny rail)
Camera weight -
585g (1lb and 5oz) without battery;
750g (1lb and 10oz) with std. battery;
840g (1lb and 14oz) with high capacity battery
Battery dimensions (H x W x D) -
87mm x 76mm x 28mm (std. battery)
87mm x 76mm x 35mm (high capacity battery)
Battery weight -
160g (6oz) (std. battery)
250g (9oz) (high capacity battery)
Charger dimensions (H x W x D) - 167mmx 112mm x 120mm
Charger weight - 550g (1lb 3oz)
Outer camera case and handle -
Radel
R-5100 and Santoprene
Rear and front bumpers -
Multiflex
or Santoprene
Lens window - Germanium (2 mm thick) with durable coating
Electrical Data
Power consumption - <3W typical
Start-up time - <5 seconds typical
Battery type - Lithium Phosphate Rechargeable Battery
Battery capacity - 1100 mAh, 6.6V (std battery); 2500mAh, 6.6V (high capacity battery)
Std Battery life -
2 hours @ ambient temperature (22 C, 72 F)
Std Battery charge time - 1 hour nominal
High Capacity Battery Life
4 hours @ ambient temperature (22 C, 72 F)
High Cap. Battery charge time - 2 hours nominal
Battery recharge cycles - Over 1000 cycles
Battery sealing - IP67
Charging temperature -
0 C to 40 C (32 F to 104 F); 65 C (150 F) can be tolerated
Charger input voltage - 10V – 32V DC (12 V and 24 V vehicle systems)
Charger operating temperature -
0 C to 40 C (32 F to 104 F)
Compliance Data
RFI/EMC
Emissions - BS EN 61000-6-3:2007, FCC CFR-47 Subpart B Class B, AUS/NZ 4251.1
Immunity - BS EN 61000-6-2:2005
Safety - IEC 60950-1 and related national standards
Vibration/Shock - BS EN 60721-3-2 Class 2M3.
RoHS - All parts of the system are compliant with EU directive 2002/95/EC
To Previous Page
Loading...
Need help?
General
