14
NA
Care and maintenance 
instructions 
Cutting off the water and electricity 
supplies
• Turnoffthewatertapaftereverywashcycle.Thiswillli-
mit wear on the hydraulic system inside the washer-dryer 
and help to prevent leaks.
• Unplugthewasher-dryerwhencleaningitandduringall
maintenance work.
Cleaning the washer-dryer
The outer parts and rubber components of the appliance 
can be cleaned using a soft cloth soaked in lukewarm 
soapy water. Do not use solvents or abrasives.
Cleaning the detergent dispenser dra-
wer
Removethedispenserby
raising it and pulling it out 
(see figure).
Wash it under running wa-
ter; this operation should be 
repeated frequently.
Caring for the door and drum of your 
appliance
• Alwaysleavetheportholedoorajarinordertoprevent
unpleasant odours from forming.
Cleaning the pump
The washer-dryer is fitted with a self-cleaning pump which 
does not require any maintenance. Sometimes, small items 
(such as coins or buttons) may fall into the pre-chamber 
which protects the pump, situated in its bottom part.
 
!  Make sure the wash cycle has finished and unplug the 
appliance.
To access the pre-chamber:
1. using a screwdriver, 
remove the cover panel on 
the lower front part of the 
washer-dryer (see figure);
2. unscrew the lid by rota-
ting it anti-clockwise (see 
figure): a little water may 
trickle out. This is perfectly 
normal;
3. clean the inside thoroughly;
4. screw the lid back on;
5. reposition the panel, making sure the hooks are securely 
in place before you push it onto the appliance.
Checking the water inlet hose
Check the inlet hose at least once a year. If there are any 
cracks, it should be replaced immediately: during the wash 
cycles, water pressure is very strong and a cracked hose 
could easily split open.
!Neverusesecond-handhoses.