6
EN
GREEN or GREEN/YEOLLOW for EARTH(E)
6. Make sure the wiring connection is tight, then close the front cover.
7. Fix back the screw A.
OPERATING INSTRUCTIONS
TO TAKE THE SHOWER FOR THE USER (see g.2)
IMPORTANT!
THE HEATER TANK MUST BE FILLED UP WITH WATER BEFORE TURN ON THE ELECTRIC SUP
-
PLY THIS IS TO PREVENT ANY DRY BURNT DAMAGE TO THE HEATING ELEMENT.
SHOULD TURN OFF THE HEATER BEFORE TURN OFF THE PRODUCT WATER SUPPLY VALVE.
STARTING
1. Turn on the product water supply valve.
2. Switch on the electric supply on the main switch out of the shower:
a. It enables the SAFETY CHECK technology to run a system scan of the product for 4 sec. and the
SAFETY CHECK led will blink:
i. If everything is running smoothly and safely the SAFETYCHECK and ELCB led will be steady.
ii. If the SAFETY CHECK led continues to blink, it is because SAFETY CHECK technology has
detected some failure and the user has to switch o the main supply and contact the service
agent for repair.
3. Turn on the product water supply valve on the product to clockwise until the water ow through
the hand shower;
4. Push
button to switch on the display and start to heat the water. The water setting temperature
and and HEATING icon
will appear on display and hot water will start owing from the shower
head;
5. Adjust the shower condition setting by:
a. Press the (plus) button to increase the temperature or push (minus) button to
decrease the temperature.
b. Turn the product water supply valve in clockwise to increase the water ow decreasing the
outlet water temperature or turn it in anticlockwise to decrease water ow increasing the outlet
water temperature
c. In rare case if inlet water is too cold, both options can be not enough to reach the desired
shower conditions.
6. Temperature setting:
a. Press the or buttons the user gradually sets the Temperature to nd the desired
shower condition and on the display he reads the temperature is going to set.
i. Pushing the temperature gradually increases, 45°C is the max setting temperature, the
hottest outlet water;
ii. Pushing the temperature gradually decreases, 32°C is the lower setting temperature.
By mode button, the user can set to take the shower at inlet temperature
iii. In case some external factors (i.e. Inlet temperature, Inlet water ow, electricity uctuation)
change, the product will modulate the power so that outlet temperature will remain con-
stant at setting temperature, guaranteeing the highest and stable comfort.
7. Select the preferred shower jet thanks to spray jet lever on the showerhead;
To Next Page
Loading...
