Ariston AURES TOP 4.5P - Pump Functioning; Display Information; Programming Shower Profile Setting

6 7
EN
8. The height and the direction of the shower head are adjustable. Depress the release button and
slide the shower holder to the desired position. Move the hand shower to the desired angle. A
ratchet mechanism in the shower holder;
9. Press the button and turn o the product water supply valve before to get out of the shower;
PUMP FUNCTIONING (only for pump version models)
The pump is always on in the pump product version. The pump starts to work when the user switches
on the product and turns on the water supply valve.
DISPLAY
On the display, the user reads the following info:
- Temperature setting when the product is working properly;
- Co = Cold shower when the user gets “cold shower prole” (see. Programming shower prole set
-
ting chapter);
- Error codes if there is some failure, below error code list for a quick diagnostic:
a. E1 = Current leakage error
b. E2 = NTC error
c. E3 = ELCB Hardware error
d. E7 = Frequency error
e. Together with Error code, Maintenance
icon appears on the display every time the product
detects some failure
Anyway every time error code appears on the display, contact the service agent for repair. NEVER try
to repair the unit by yourself.
PROGRAMMING SHOWER PROFILE SETTING
Pressing MODE button the shower programming prole will be activated. Programming prole func
-
tion allows to the user to memorize up to 3 shower temperature prole:
1. Shower prole 1
a. Firstly, press MODE button to start to operate the Programming Shower Prole and the shower
icon P1
will appear, temperature digits blink.
b. Pressing or the user changes its desired shower temperature setting.
c. Set the desired temperature, the temperature digits will blink for 3 sec. then it becomes xed
and memorizing the temperature shower prole P1.
Every time the user will set P1 shower prole, he will take shower at the last P1 setting temperature.
2. Shower prole 2
a. From Shower prole P1 setting, pressing again MODE button the user will go to set Shower
Prole 2, The shower icon P1 disappears, the shower icon P2
will appear and temperature
digits blink.
b. Repeat the same actions (b, c) above illustrated on shower prole 1.
3. Shower prole 3
a. From Shower prole P2 setting, pressing again MODE button the user will go to set Shower
Prole 3, the shower icon P2 disappears, the shower icon P3
will appear and temperature
digits blink
b. Repeat the same actions (b, c) above illustrated on shower prole 1.
1
2
3