REPAIR MANUAL
Page: 12
13. MAIN MOTOR
Fig. 13-1
Fig. 13-2
Fig. 13-3
• To remove the Main Motor, first remove the Drive Belt and then the two (2) 13 mm Motor Mounting Plate Bolts (Fig. 13-1). The
Main Motor has three support points, two in the front (A) and a third located on a Rear Mounting Bracket that supports the Motor on
the rear left side (Fig. 13-2). Brace the Motor as you remove the two Mounting Plate Bolts, when both bolts are clear bring the
Motor out toward you freeing it from the rear support (Fig. 13-3). Remove the two (2) 8mm Bolts that attach the Plate to the Motor.
A
A
AW 120 / AW 122 / AW 125
AWD 120 / AWD 121 / AWD 129
To Next Page
Loading...
