The washer-dryer
does not drain or
spire
Does the selected program
incorporate water drai-
ning? Some programs stop
at the end of the wash cycle
and draining will have to be
selected manually.
@ts the "Easy iron" function
-where provided - enabled?
This function requires
manual selection for
draining.
@te the drain pump clogged?
To check it, turn off the water
suppIy, unplug the washer-
dryer and follow the
instructions on page 18, or
calI technical support.
rE_s_
Cleaning Filters
l_ls the drain hose kinked?
The drain hose must be as
straight as possible. Make
sure the drain hose is not
crimped or kinked.
_J Is the washer:dryer's drain
hose clogged? Is there an
extension of the drain hose?
If so, is it positioned
incorrectly, blocking the
water flow?
¢
Excessive vibration
during the spin cycle,
_]Have all shipping bolts
been removed during
installation? See the
following page on
installation procedures.
_] Has the washer=dryer been
levelled correctly? The
levelling of the appliance
should be checked
periodically. Adjust the feet
and check them with a level.
using tweezers, : _ /_"_ 1
c,e..n..ndrop,..ce j
t H: .emove
tt .!_,td_-,_'J _-. _" -. filters, clean _
",, X, \
Drain: to avoid flooding Tape
be careful to the adjust the drain
hose to at least _
25" above the base
of the appliance.
Fasten the hoses securely.
_Jle there space between the
machine and adjacent
units? If it is not a built-in
model, the washer-dryer will
oscillate a bit during the spin
cycle. A few cm of space
should therefore be left
around it.
ii
The washer-dryer
leaks.
_JIs the metal ring of the inlet
hose properly attached?
Turn off the water supply,
unplug the appliance and try
tightening its attachment
without forcing it.
_j Is the detergent dispenser
obstructed? Remove and
wash it under tap water.
_Jle the drain hose well
attached? Turn off the water
supply, unplug the
appliance and try tightening
its attachment.
ill
Too much foam.
l_ Is the detergent appropriate
for machine washing? Check
whether the definition on its
label reads "for machine wash"
or <<handand machine wash",
or any other similar wording.
@Is the correct amount being
used? An excessive amount of
detergent, besides producing
too much foam, does not
guarantee a more effective
wash, and causes scaling in the
internal parts ofthe appliance.
The washer-dryer
does not dry,
@ Check whether:
the plug has been correctly
inserted into the socket; there
is electricity in your home; the
appliance door has been shut
properly; a delayed start (if
available) has not been
selected; program knob A
has been set to Reset and
the drying cycle knob C has
been set to position
0 minutes.
The washer-dryer doesn't
dry property.
@ Check whether:
1) the end of the drain hose
is underwater; 2) the drain
pump is obstructed; 3) the
advice given on the maxi-
mum loads has been taken;
4) the water tap has been
turned on.
If, despite all checks, the
washer-dryer fails to function
and the problem persists, call
your nearest authorized
Customer Service Centre,
1o800=426o0825 providing the
following information:
- the nature of malfunction
- the model type no. (Mode ooo.)
- the serial number (SIN .°°.)
This information can be found
on the data plate situated at the
back of the washer-dryer.
www, aristonapp[iancee,ue lnstrucdonsforinstalla_ionanduse1=1
To Next Page
Loading...
