ARISTON DISHWASHER - Instructions for installation and use
15
D
1509)50-4
Detergent and rinse aid
The rinse aid.
This product makes dishes sparkle
more as it improves their drying.
The rinse aid container is situated
on the inside of the door: It should
be filled up when the low rinse aid
indicator light "T" flashes.
Loading the rinse aid.
To open the dispenser, turn cap C
anticlockwise. Take care when you
pour in the rinse aid to avoid it
overflowing. You can adapt the
amount of rinse aid used by the
dishwasher: regulate the adjuster
F which you will find under lid C.
The detergent
Loading the detergent
To open lid A, press button B. The
detergent should be poured into
the two containers C and D up to
the rim.
Now you can close the lid: press it
down until you hear it click.
If you prefer to use the detergent
in tablets, place one of these in
container "D". Now you can close
the lid: press it down until you
hear it click.
It won't close!
Check whether there is any
detergent residue on the edges
of the dispenser. It is due to this
residue that the lid won't close.
Get rid of it and you'll see that it
closes.
Only use specific dishwasher detergents. Pour the detergent into the dispenser
on the inside of the door. Before the wash cycle starts!
Useful tips
Proper dosage of
the rinse aid
improves drying.
If drops of water
remain on the
dishes or spotting
occurs, turn the
dosage adjuster to a
higher setting.
If, on the other
hand, the dishes
have white streaks,
then turn the
dosage adjuster
down to a lower
setting.
You can choose from six different
positions. It is normally set to 4.
Use the right amount
of detergent: if you use
too much, you will not
get cleaner dishes, but
just more
environmental
pollution.
Keep your
dishwasher
detergent and
rinse aid in a
cool, dry place
and away from
children.
B
D
C
A
Warning
Three-in-one dishwasher tablets are now available on the market, and combine detergent, salt and rinse aid all in one.
If the water in your area is hard or very hard, we still recommend you pour extra salt into the relevant dispenser to prevent the
formation of white streaks on your dishes or on the interior of the appliance.
Using a three-in-one product means it is no longer necessary to put rinse aid into the relevant container.
If you want to achieve perfectly dry dishes, you may add rinse aid as long as the dosage adjuster is set to no.2.
In any case, please read the manufacturer's instructions on the packet.
If you use only these products, it is normal for the salt and rinse aid indicator lights to flash permanently after a certain number of
cycles.
F
C
To Next Page
Loading...
