GB
5
THE APPLIANCE MUST BE EARTHED
The appliance is designed to work with alternating
current at the supply voltage and frequency indicated
on the rating plate (situated on the rear part of the
appliance and on the last page of the instruction
booklet) or at the end of the instruction booklet. Make
sure that the local supply voltage corresponds to the
voltage indicated on the rating plate.
ATTENTION: This appliance has a maximum power
exeeding 3kW; it is therefore necessary for it to be
connected to a socket able to support a rated
current higher than 13A (the appliance rated current
is 15A). Connecting the supply cable to
the mains
electricity supply A 13. A plug in compliance whit
BS 1362 is not suitable.
To connect directly to the mains supply, a double-pole
switch with a contact separation of at least 3 mm
suitable for the load and complying with current
standards and regulations, must be fitted between the
appliance and the mains supply outlet. The yellow-
green earth wire must not be interrupted by the switch.
The supply cable must be in such a position that no
part of it can reach a temperature of 50 °C above room
temperature. Do not use adapters or shunts as they
could cause heating or burning. Before connecting to
the power supply, make sure that:
the limiter valve and the domestic system can
withstand the load from the appliance (see rating
plate);
the supply system is efficiently earthed according to
standards and laws in force;
the socket or double-pole switch are easily
accessible when the appliance is installed.
FAILURE TO OBSERVE THE ACCIDENT-PREVENTION
REGULATIONS RELIEVES THE MANUFACTURER OF
ALL LIABILITY.
Electrical connection
Important: the wires in the mains lead are coloured in
accordance with the following code:
Green & Yellow - Earth
Blue - Neutral
Brown - Live
As the colours of the wires in the mains lead may not
correspond with the coloured markings identifying the
terminals in your plug, proceed as follows:
Connect the Green & Yellow wire to terminal marked
E or
or coloured Green or Green & Yellow.
Connect the Brown wire to the terminal marked L or
coloured Red.
Connect the Blue wire to the terminal marked N or
coloured Black.
Replacing the cable
Use a rubber cable of the type H05VV-F with a suitable
cross section 3 x 4 mm².
The yellow-green earth wire must be 2-3 cm longer than
the other wires.
TECHNICAL FEATURES:
Voltage and Frequency 240 V ~ 50 Hz
Max. absorption: 9900 W
To Next Page
Loading...
