EasyManua.ls Logo

Ariston egis premium 25 - Page 8

Ariston egis premium 25
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
launam sresu
OK
ESC
conditions
The boiler is protected from malfunctions by means of internal
checks performed by the electronic P.C.B., which stops the boiler
in this manner, a code appears on the control panel display which
and the reason behind it.
may occur:
This type of error is “volatile, which means that the boiler
starts up again automatically as soon as the problem
is removed. On the display
ash “Err and the error code
(es. Err/110) and appear
the symbol
- see the error table.
disappears, the
boiler starts up again and continues to operate normally.
for safety reasons, it is possible to attempt
and on
again using the ON/OFF button on the control panel.
. Make sure the
the gas valve
ed technician.
cient water pressure
si tiucric gnitaeh eht edisni erusserp retaw eht fI
.
ash “Err” and the code - Err/108 - for
cient water pressure -- see the error table.
Check the water pressure on the pressure gauge and
make sure that is between 0.6 and1.5 bar when the
ll the
system by open the valve under the boiler.
If the pressure drops very frequently, there may be a water leak at
some point in the system. If this is the case a plumber should be
contacted.
Operation shutdown
This type of error is “non-volatile”, which means that it is not removed
automatically.
ash Err and the error code -es. Err/501 , and
appear the symbol
.
In this case the boiler does not restart automatically, but it may
be reset by pressing the
button. If the problem manifests
itself again after several attempts to reset the appliance, contact a
ed technician.
Important
If this shutdown occurs frequently, contact an authorised service centre
for assistance. For safety reasons, the boiler will allow a maximum of 5
reset operations to take place in 15 minutes (individual presses of the
button).
If the shutdown is occasional or an isolated event, this is not
Necessarily a problem.
液晶屏上Err和错误代码交替显示(如Err/110)并出现
符号。
如果热水炉因为安全关闭停机,可以通过尝试按控制面板上的
ON/OFF键来重新启动机器。
液晶屏上Err和错误代码交替显示
(如Err/108)-需要补水。
液晶屏上Err和错误代码交替显示(如Err/501)并出现符号 。
用户手册

Related product manuals