8
ARISTON DISHWASHER - Instructions for installation and use
D
ISHWASHER
If the power
socket to which
the appliance is
connected is not
compatible with
the plug, replace
it with a suitable
plug rather than
using adapters or
multiple plugs as
these could cause
overheating or
burns.
Installation and moving
After having bought or moved your dishwasher to another home, a
correct installation ensures that your dishwasher will operate
smoothly and efficiently.
nection. If this precaution is not
taken, the water inlet could get
blocked, causing damage to your
dishwasher.
Drain hose connection
Fit the drain pipe into a drain line
with a minimum diameter of 4 cm
or place it over the sink. Avoid
restricting or bending it. Use the
special plastic elbow provided (see
figure) to position it in the best
possible way. The part of the pipe
marked with the letter A should be
between 40 and 100 cm above the
ground.
The pipe should not be immersed
in water.
Electrical connection.
First of all, check that the mains
voltage and frequency values cor-
respond to those stated on the rat-
ing plate located on the stainless
steel inner door of the appliance
and that the electrical system to
which the dishwasher is connected
is sized for the maximum current
indicated on said rating plate.
Earth: indispensable
safety.
Only now can you plug the appli-
ance into a socket provided with
an efficient earth connection (the
systems earthing is a guarantee of
safety provided for by law, make
sure your system has it).
Choose where you want to install
your dishwasher, you can even
place it so that its sides or back
panel are side by side with furni-
ture or up against the wall. The dish-
washer is provided with water sup-
ply and drain hoses, which can be
directed towards the left or right to
facilitate appropriate installation.
This dishwasher model can be built
under a single worktop (please read
the relevant instruction sheet).
Levelling.
Once the appliance is positioned,
adjust the feet by screwing them
in or out depending on how high
you want it and level it so that it is
horizontal. Make sure that it is not
inclined more than 2 degrees. If the
appliance is level, it will help en-
sure its correct operation.
Cold water connection.
This electric household appliance
should be connected to the water
mains using the cold water supply
hose provided with the appliance
only. Do not use a different hose. In
the event of replacements, use
original spare parts only.
Connect the cold water supply
hose to a 3/4 gas threaded
connection taking care to screw it
tightly onto the tap.
If the water hoses are new or have
been out of use for an extended
period of time, let the water run to
make sure it is clear and free of
impurities before making the con-
Your dishwasher has arrived
A
The special
plastic elbow
should be
fastened firmly
onto the wall to
prevent the drain
hose from
moving and
allowing water to
spill outside the
drain.
Power supply wire.
Check the power supply wire on a
regular basis; if it is damaged, we
recommend you have it replaced
by an authorised technical Assist-
ance service centre.
The plug
Warning!
The dishwasher plug must be
accessible,so that maintenance
can be done safely.
To Next Page
Loading...
