ARISTON DISHWASHER - Instructions for installation and use
15
D
ISHWASHER
Detergent and rinse aid
The rinse aid.
This product makes dishes
sparkle more as it improves their
drying. The rinse aid container is
situated on the inside of the door:
It should be filled up when the low
rinse aid indicator light "T"
flashes.
Loading the rinse aid.
To open the dispenser, turn cap
C anticlockwise. Take care
when you pour in the rinse aid
to avoid it overflowing. You can
adapt the amount of rinse aid
used by the dishwasher:
regulate the adjuster F which
you will find under lid C. You
can choose from six different
positions.
The detergent
Loading the detergent
To open lid A, press button B.
The detergent should be
poured into the two containers
C and D up to the rim.
Now you can close the lid:
press it down until you hear it
click.
If you prefer to use the
detergent in tablet form, then
place one inside the container
D and close the lid.
It won't close!
Check whether there is any
detergent residue on the edges
of the dispenser. It is due to this
residue that the lid won't close.
Get rid of it and you'll see that
it closes.
Only use specific dishwasher detergents. Pour the detergent into the dispenser on the inside of
the door. Before the wash cycle starts!
Use the right
amount of
detergent: if you use
too much, you will
not get cleaner
dishes, but just
more environmental
pollution.
Keep your
dishwasher
detergent and rinse
aid in a cool, dry
place and away
from children.
Useful tips
You can choose from six different
positions. It is normally set to 4.
Warning
Three-in-one dishwasher tablets are now available on the market, and combine detergent, salt and rinse aid all in one.
If the water in your area is hard or very hard, we still recommend you pour extra salt into the relevant dispenser to prevent the
formation of white streaks on your dishes or on the interior of the appliance.
Using a three-in-one product means it is no longer necessary to put rinse aid into the relevant container.
If you want to achieve perfectly dry dishes, you may add rinse aid as long as the dosage adjuster is set to no.2.
In any case, please read the manufacturer's instructions on the packet.
If you use only these products, it is normal for the salt and rinse aid indicator lights to flash permanently after a certain number
of cycles.
Proper dosage of the
rinse aid improves
drying.
If drops of water
remain on the dishes
or spotting occurs,
turn the dosage
adjuster to a higher
setting.
If, on the other hand,
the dishes have white
streaks, then turn
the dosage adjuster
down to a lower
setting.
F
C
B
D
C
A
To Next Page
Loading...
