18
ARISTON DISHWASHER - Instructions for installation and use
D
ISHWASHER
If the power socket
to which the
appliance is
connected is not
compatible with the
plug, replace it with
a suitable plug
rather than using
adapters or multiple
plugs as these could
cause overheating or
burns.
Installation and moving
After having bought or moved your dishwasher to another home, a correct installation ensures that your dishwasher will operate
smoothly and efficiently.
will be about 15 minutes
shorter and the wash will be
slightly less effective.
The connection must be made
to hot water supply following
the same procedures as those
indicated for the cold water
connection.
Drain hose connection.
Fit the drain pipe into a drain
line with a minimum diameter
of 4 cm or place it over the sink.
Avoid restricting or bending it.
Use the special plastic elbow
provided (see figure) to posi-
tion it in the best possible way.
The part of the pipe marked
with the letter A should be be-
tween 40 and 100 cm above the
ground.
The pipe should not be im-
mersed in water.
Electrical connection.
First of all, check that the mains
Choose where you want to
install your dishwasher, you
can even place it so that its
sides or back panel are side by
side with furniture or up against
the wall. The dishwasher is
provided with water supply and
drain hoses, which can be
directed towards the left or
right to facilitate appropriate
installation.
This dishwasher model can be
built under a single worktop
(please read the relevant in-
struction sheet).
Levelling.
Once the appliance is
positioned, adjust the feet by
screwing them in or out
depending on how high you
want it and to level it so that it
is horizontal. Make sure that it
is not inclined more than 2
degrees. If the appliance is
level, it will help ensure its
correct operation.
Anti-flooding protection
Your dishwasher is provided
with a special system which
blocks the water supply in the
event of leaks inside the appli-
ance.
Cold water connection.
Connect the cold water supply
hose to a threaded 3/4 (gas)
connector, and making sure
that it is fastened tightly in
place. If the water hoses are
new or have been out of use for
an extended period of time, let
the water run to make sure it is
clear and free of impurities
before making the connection.
If this precaution is not taken,
the water inlet could get
blocked, causing damage to
your dishwasher.
Hot water connection.
Your dishwasher can be
supplied with hot water from
the mains supply (if you have a
central heating system with
radiators) at a temperature of
no more than 60°C.
In this case, the wash cycle time
Your dishwasher has arrived
voltage and frequency values
correspond to those stated on
the rating plate located on the
stainless steel inner door of the
appliance and that the
electrical system to which the
dishwasher is connected is
sized for the maximum current
indicated on said rating plate.
Earth: indispensable
safety.
Only now can you plug the
appliance into a socket
provided with an efficient earth
connection (the system's
The special plastic
elbow should be
fastened firmly onto
the wall to prevent
the drain hose from
moving and allowing
water to spill outside
the drain.
A
earthing is a guarantee of safety
provided for by law, make sure
your system has it).
Power supply wire.
Check the power supply wire
on a regular basis; if it is
damaged, we recommend you
have it replaced by an
authorised technical
Assistance service centre.
The plug
The dishwasher plug must be
accessible even when the
appliance is installed so that
maintenance can be done
safely.
To Next Page
Loading...
